Specifications Of Supported Single And Multi-Part Forms - Toshiba SureMark 4610 2CR Hardware Manual

Note: When selecting a paper, ensure that the paper's archive life meets the requirements of the
tax authorities of your country for archiving tax-related data.
Thermal paper
The paper used in the thermal receipt station must meet the following requirements:
Width
79.5 ± 0.5 mm (3.13 ± 0.02 in.)
Outside Diameter
102 mm (4.0 in.) maximum
Thickness
57 μm (0.00225 in.) Range: 41 μm (0.0016 inches) minimum to 99 μm (0.0039) maximum
Paper has a significant manufacturing tolerance and nominal paper designations do not
reflect actual measurements. The manufacturing tolerance must fall within the published
operating thickness range. You should test paper in your specific configuration before
using. If any spot measurement of the paper is outside the specified range, the paper does
not meet the paper specification, which will result in an end-user error paper jam.
To find supported papers:
1. Visit the Toshiba Global Commerce Solutions support website at
www.toshibacommerce.com/support.
2. Select SureMark Printers.
™
3. Click on OEM Paper Testing under 4610-2CR/2NR to view the supported papers.
Attention: Printer reliability and performance are directly related to the quality of the supplies
you use. The published parameters for printer performance are established using supplies that
meet the specifications listed above.
Thermal paper with watermarks, coupons, or advertisements printed on the front or back of the
paper is not covered by Toshiba specifications. Some inks and printing processes will work
acceptably, while others will not. Printer problems that are caused by supplies that do not meet
Toshiba specifications might result in a billable service call, regardless of the existence of a
service contract.
Impact printing
With thermal impact station printing, both models can print up to three parts on a multi-part
form. Table 12 lists the specifications of supported single and multi-part forms.
• Test all forms in the printer to ensure acceptable performance prior to buying a significant
quantity.
• No binding holes or other holes should be within 10 mm (0.4 in.) from the right edge of the
form.
• Forms less than 0.15 mm (0.006 in.) thick with the grain of the paper perpendicular to the feed
direction (short-grain paper) should not be used for landscape printing.
• All documents with color will feed properly in the impact printing station. You should verify
your documents before use. See Figure 3 for document specification details.
Table 12. Specifications of supported single and multi-part forms
Specification
Minimum width:
Value
50 mm (2 in.)
Chapter 4. Using and maintaining the 4610 printer
41