Cable Connections And Pin Assignments; Figure 2: Vga-Interface - Siemens SCD 1597 Operating Instructions Manual

2.3. Cable Connections and Pin Assignments

The LCD-monitor has been tested and set-up in the factory. Before use, the power supply
and the VGA signals should be connected to the sockets provided. Connections to the
monitor should adhere to EMC regulations.
A high-quality 75-ohm coaxial cable must be used for the VGA-signals. Low quality cables
can result in interference and shadowing on the display.
VGA-Interface
The VGA interface is a standard 15-pin male HD-D-type connector.

Figure 2: VGA-interface

Pin Signal
1 Video input RED
2 Video input GREEN
3 Video input BLUE
4 Not used
5 Not used
6 GND (RED)
7 GND (GREEN)
8 GND (BLUE)
9 Not used
10 GND
11 Not used
12 Not used
13 H-Sync.
14 V-Sync.
15 Not used
LCD-Monitor SCD 1597-R/RT/R8S Page 11 / 22
Operating Instructions
DOC-Nr.: B3 0038 D4.DOC