Default Settings - Zte ZXV10 W300 User Manual

ZXV10 W300 Wireless ADSL Router User Manual
If a telephone needs to be installed before the splitter, the user
must connect a voice filter in the Line port of the splitter; then
connect the telephone after the voice filter. The other port
connections can be referred to Figure 3.
A splitter consists of three ports:
Line: The port connected to the ADSL subscriber line.
Modem: The port connected to DSL port of W300.
Phone: The port connected to a telephone.
3. Use an RJ-45 cable to connect the W300's LAN1 port to a
computer or another network device.
4. Connect the power adapter to the device and plug the power
adapter to the AC power outlet. W300 will be on after pushing
the power switch button.

Default Settings

The factory default settings for a W300 router are listed as follows:
IP address: 192.168.1.1; subnet mask: 255.255.255.0.
Use the DHCP server by default (i.e., the IP address can be
obtained from the W300 router automatically via DHCP).
Line coding:
/ADSL2+).
To log into the configuration page of W300, use the username and
password marked on the label of W300 cover.
Default network
encryption mode, and encryption key are also marked on the label
of the W300 cover.
6 Confidential and Proprietary Information of ZTE CORPORATION
Caution: Please use the companion power adapter. The
other power adaptor may make W300 unable to work
normally or even damage it.
Auto negotiation
name (SSID)
(T1.413/G.DMT/G.LITE/ADSL2
for WLAN (Wi-Fi), wireless