SAFETY DEVICES & EMERGENCY STOP
Automatic Emergency Safety Features
As the RoboCut is operated by remote control and the user is not directly operating the driving
elements of the machine specific safety features have been built in to protect the user, third
party persons and the machine itself; these are as follows
Danger / Risk Situation
Machine beyond signal reception area or radio signal blocked.
Radio signal failure.
Another machine on same frequency operating in the area.
Manual Emergency Safety Feature
In addition to the automatic safety features stated above the operator can immediately stop the
machine either by pressing the Emergency Stop button located on the remote control unit or by
pressing the Emergency Stop button located on the top panel of the machine itself.
In all instances stated above, emergency stopping of the machine will take a maximum of 0.2
seconds from execution of the automatic or manual command and the following actions will
occur;
Engine will be switched off
Ignition will be turned off.
Machine movement will be halted.
Electrical voltage will be deactivated.
Entire electrical system will be disabled.
In the unlikely event of movement malfunction
If machine movements perform in an unexpected or incorrect manner follow the instructions
below;
1) Release the forwards/backwards movement joystick – the control is equipped with automatic
zero position; on release it will automatically return to the central (stop) position, this action
activates the track brakes.
2) Press the Emergency Stop button on the control unit.
DANGER! Do not approach the machine if it is moving.
3) Press the machine's Emergency Stop button.
4) Turn the ignition key into the off position (anti-clockwise) and remove the key.
Contact your Authorised Dealer or McConnel Service – do not attempt to operate the
machine until advice has been sought.
Automatic Safety Feature
EMERGENCY STOP will activate.
EMERGENCY STOP will activate.
EMERGENCY STOP will activate.
7
Need help?
Do you have a question about the ROBOCUT and is the answer not in the manual?
Questions and answers