Installing An Rru Aisg Multi-Wire Cable And Aisg Extension Cable - Huawei DBS3900 Installation Manual

RRU3249
Installation Guide
Step 7 Attach color-coding to the installed RF jumper according to the instructions in Attaching the
Color Ring.
----End
7.7 Installing an RRU AISG Multi-Wire Cable and AISG
Extension Cable
This section describes the procedures for installing an RRU AISG multi-wire cable and AISG
extension cable.
Context
When the distance between an RRU and a Remote Control Unit (RCU) is longer than 5 m (16.4
ft.), an AISG multi-wire cable is not long enough to connect the RRU and the RCU. In this case,
an AISG extension cable is used to extend the AISG multi-wire cable.
Procedure
l
Issue DraftA (2015-05-30)
Install an AISG multi-wire cable that is not configured with an AISG extension cable.
1. Use an M3 flat-head screwdriver to loosen the screws on the dustproof cap on the RET
port and remove the dustproof cap.
2. Link the waterproofed DB9 connector at one end the AISG multi-wire cable to the
RET port on the RRU bottom, as shown in
Figure 7-17 Installing an RRU AISG multi-wire cable
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Installing RRU Cables
Figure 7-17.
49