Operating Guide
Important: To ensure your pet does not receive an unintended correction, make sure your pet
is not wearing the Computer Collar® unit when turning ON or adjusting the Indoor Shields® Plus
transmitter.
1. Charge the Indoor Shields® Plus Transmitter
• Lift the rubber cover protecting the charging jack located on the Indoor Shields® Plus
transmitter. Connect the charger connector to the charging jack with the keyed side facing
down.
• Plug the AC adaptor (RAC00-13701) into a standard 120 volt wall outlet
• Allow the unit to charge a full 4 hours before initial use and after prolonged storage. A charge
time of 2 hours is required after the initial charge for normal charging.
• Charge indicator light will be yellow while charging
• Charge indicator light will turn off once charge is complete
• When charging is complete remove the charger connector and replace the rubber cover.
• Battery life of approximately 30 days can be expected from a fully charged battery.
• The Indoor Shields® Plus transmitter will give an audible chirp once every 30 seconds when
the battery is low.
2. Turning On and Off
• Turn on by pressing RANGE UP (+) button.
• Turn off by pressing RANGE DOWN (-) button until LCD no longer displays signal field range.
Illustration A
www.InvisibleFence.com
Indoor Shields®
Plus Transmitter
Rubber Cover
Charger Connector
6
Need help?
Do you have a question about the Indoor Shields Plus and is the answer not in the manual?
Questions and answers