2. Train your pet according to the instructions in the Invisible Fence Brand training manuals. Complete all steps before ® allowing your pet to run free. Do not become overly confi dent if your pet has become conditioned to the Invisible Fence Brand pet containment system sooner than expected. ®...
How the System Works ® ® The 800 Series Transmitters are designed to work with an Invisible Fence Brand Titanium Computer Collar unit to contain your pet within areas you choose, or teach your pet to avoid specifi c areas such as fl ower beds, gardens, or pools.
Operating Guide ® The Titanium Computer Collar Unit ® The Titanium Computer Collar unit is a patented microprocessor-controlled device, powered by a patented Power Cap ® unit. Note: ONLY use the post tightening tool to tighten the correction posts. Use of other tools will void the warranty.
If a fresh Power Cap unit is not ® ® available, contact your Invisible Fence Brand Dealer for a replacement. Once a replacement Power Cap unit is installed and ® the signal fi eld checked (see page 7 for instructions on checking the signal fi eld), put the Titanium Computer Collar unit on your pet.
Access S1 or S2 by gently pulling the tab at the bottom of the cover towards you. Once released at the bottom, the top will come off the base. 800 Series Transmitter Status Light and Audible Alarm Troubleshooting...
If the receiver does not sound a warning tone where the edge of the signal ® is supposed to be, immediately call your Invisible Fence Brand Dealer for service. Use a leash (lead) or other means to contain your pet until all necessary service has been completed.
® Transmitter: At the end of product life of the Transmitter, please contact your Invisible Fence Brand Dealer to receive instructions on proper disposal of the backup battery (if installed). Please do not dispose of the unit in household or municipal waste.
Compliance US and Canada FCC ID: KZ3-050261 IC: 2430A-050261 This device complies with Industry Canada rules. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the 800 Series and is the answer not in the manual?
Questions and answers
how do I adjust correction level on the 800 series collar