Table of Contents
Advertisement
2 Indicators
BETACAM SX
ALARM indicator
ALARM
GOOD SHOT
REC
KEY
KEY INHIBIT indicator
INHIBIT
SERVO
SERVO indicator
GOOD SHOT REC INHIBIT indicator
BETACAM SX indicator
When playing back a tape recorded in Betacam SX
format, this indicator lights.
ALARM indicator
This lights when a hardware error is detected on the
unit, and goes off when the error is resolved.
When this indicator is lit, an error message appears in
the fluorescent display. If you are using the SDI
OUTPUT 3 (SUPER) or COMPOSITE VIDEO
OUTPUT 3 (SUPER) connector, then when the
CHARACTER switch in the subsidiary control panel
is set to ON, the error message also appears on the
monitor screen.
KEY INHIBIT indicator
This indicator lights when the KEY INHIBIT switch
on the subsidiary control panel is set to ON.
SERVO indicator
When the drum servo and capstan servo are locked
this indicator lights.
GOOD SHOT REC (recording) INHIBIT indicator
This indicator is on or off according to the
combination of the setting of the GOOD SHOT switch
on the subsidiary control panel and the record inhibit
plug on the cassette, as shown in the following table.
When this indicator is on, recording shot marks on
tape is prohibited.
..........................................................................................................................................................................................................
1) Servo lock: This refers to the synchronization of the
phase of the drum rotation and the reference signal for
the tape transport position, so that the video heads can
trace the same pattern on the tape for playback or
recording.
BETACAM SX indicator
1)
,
GOOD SHOT REC INHIBIT indicator indications
GOOD SHOT
State of the record inhibit
switch position
plug on the cassette
REC INHIBIT
Record inhibit/permit
REC
Record inhibit
Record permit
3 DMC playback control section
1 DMC MODE button
2 MEMORY indicator
3 DELETE
button
DMC MODE
DELETE
MEMORY
LEARN
CUE/PLAY
6 CUE/PLAY button
5 LEARN button
1 DMC MODE button
Use this button when you make settings for DMC
playback and when you carry out playback in feed-
mode.
See page 4-6 for details of DMC playback, and see page 4-5
for details of playback in feed mode.
2 MEMORY indicator
When memorizing the playback speed using the DMC
MODE button, this indicator flashes as the playback
speed is captured to memory, and lights continuously
once the speed is captured.
Chapter 2 Location and Function of Parts
GOOD SHOT
REC INHIBIT
indicator state
Lit
Lit
Off
4 TRIM buttons
TRIM
+
–
PLAY
IN
OUT
ENTRY
STUNT
OUT
IN
7 DMC playback control
point setting buttons
2-7
Advertisement
Table of Contents
