Pioneer DDJ-RB Service Manual page 41

5
(5) Insert the Jog dial in the shaft bearing while turning it.
Jog dial
(6) Turn the control panel over then wipe off the excess
grease.
• Bottom view
(7) Put the washer (WA62D095D050) on the shaft.
• Bottom view
5
6
Jog dial
Washer
6
7
(8) Put the washer (YC60FAC) on the groove of the shaft.
The washer must be properly fit with the groove.
(9) Turn the control panel over then check that the Jog
dial rotates properly.
(10) Perform manual running-in rotations of the Jog dial,
as indicated below.
1 Turn the Jog dial manually 50 rotations.
2 Perform failure judgment of the Jog dial.
For details on the measurement method, see
"2-1: Measurement mode of the load of JOG dial" in
"6. SERVICE MODE."
3-1 In a case of failure because of excessive load,
repeat the following procedure until a good result is
obtained in failure judgment.
Manually turn the Jog dial 50 rotations then
perform failure judgment of the Jog dial again.
3-2 In a case of failure because of insufficient load,
apply grease again.
(Repeat the above procedures from Step (1).)
Note:
After disassembly, be sure to wipe off any externally
accessible grease.
DDJ-RB
7
8
• Bottom view
Washer
NG
• Bottom view
8
A
B
C
D
E
F
41