Pioneer DDJ-RB Service Manual page 40

1
A
Procedure for applying grease during reassembly of the Jog dial
[Cases where the Jog dial is required to be detached]
· When the Jog dial is to be replaced
· When the control panel is to be detached for replacement
After the control panel is detached, carefully wipe off the grease from the Jog dial, as well as from the shaft bearing, then
apply new grease, in the following manner:
Grease to be used: GEM1100
(1) Apply grease to the tip and base of the shaft of the Jog
dial, one round each.
B
C
• Bottom view
(2) Put a washer (WA62D095D050) on the shaft and place it
at the base of the shaft.
D
E
• Bottom view
F
40
1
2
Shaft
Jog dial
Washer
Jog dial
DDJ-RB
2
3
(3) Apply grease lightly to the shaft bearing of the control
panel up to a depth of approximately 10 mm from the
upper-panel side. Then turn the control panel over and
apply grease from the opposite side in the same manner.
Control panel
• Bottom view
(4) Turn the control panel over again then apply a small
amount of grease to one point of the shaft bearing on
the upper-panel side.
3
4
Shaft bearing
Shaft bearing
Shaft bearing
4