Error Messages On The Cycle Computer - Shimano STEPS E7000 SERIES User Manual

„ Error messages on the cycle computer
Warnings
This disappears if the error is fixed.
List of warnings
Display
Code
preconditions
Temperature of the
drive unit is higher
W010 than it is during
times of normal
operation.
The traveling speed
W011
cannot be detected.
Initialization of
torque sensor was
W013
not completed
successfully.
An electronic
derailleur may have
been installed in
W032
place of a
mechanical
derailleur.
Operational restrictions
while warning is
displayed
Power assistance may
be lower than usual.
The maximum speed up to
which power assistance is
provided may be lower than
usual.
Power assistance may
be lower than usual.
Power assistance
provided in [WALK]
mode may be lower
than usual.
* The Walk assist mode
function may not be
able to be used in
certain regions.
46
Remedy
Stop using the assist function until the temperature of
the drive unit drops.
If the situation does not improve, contact the place of
purchase.
Check that the speed sensor is properly installed.
If the situation does not improve, contact the place of
purchase.
With your foot off the pedal, press the battery power
button and turn on the power again.
If the situation does not improve, contact the place of
purchase.
Reinstall the derailleur for which the system is
configured to support.
If the situation does not improve, contact the place of
purchase.