Switching To [Walk] Mode (Walk Assist Mode) - Shimano STEPS E7000 SERIES User Manual

„

Switching to [WALK] mode (walk assist mode)

• The use of the walk assist mode function is prohibited by law in some regions.
• The walk assist function operates at a maximum of 6 km/h. During electronic gear shifting, the assist level and speed are
controlled by the gear position.
• If Assist-Y is not pressed for at least one minute, the system will restart in the mode that was set prior to setting [WALK]
mode.
• The intelligent walk assist function activates when an electric shifting system such as XTR, DEORE XT SEIS is connected.
System individually supplies assist power to detect gear position.
"Intelligent walk assist" support rider more torque output in steep climb condition in lower side gears.
"Quick walk assist" function works quickly by holding down SW from any mode.
Switching to walk assist mode
1.
Hold down Assist-Y until it reaches the following
state.
• SC-E7000: The assist mode shown on the display
switches to [WALK].
• EW-EN100: The LED (inner side) lights up blue.
Assist
Y
If it is impossible to switch to [WALK] mode for any reason (such as the speed not being [0 km/h] or there being
pressure applied to the pedals), a warning sound will be played when switching.
Y
Assist OFF
LED lamp (inner side)
NOTE
30
<SC-E7000>
<EW-EN100>
Walk assist mode
enabled