Table of Contents
Advertisement
6
Commissioning
Preparation
5.1 Preparation
24
Building Technologies
Fire Safety
For manual call point FDM243H, the surface-mounted cables are fed into the
housing from below.
1
2
1
Key
2
Keyhole cover
3
Allen head screws
Fastening material and an Allen key SW 3.0 are available.
1. Push the keyhole cover (2) to the right.
2. Open the door with the key supplied (1).
3. Pull out the key and keep it in a safe place.
4. Close the keyhole cover.
Do not unscrew the four cross-head screws on the switching unit.
5. Unscrew the four Allen head screws (3) and remove the switching unit (4).
6. Determine how the cable should be entered in the housing from below.
-
Remove the cable gland (6), which is not required, and insert a V-pin
M20 x 1.5 (5).
Do not remove or damage the screw connection on the rear wall of the housing.
The manual call point is now prepared for installation.
3
4
5
4
Switching unit
5
V-pin
6
Screwed cable gland
6
A6V10374021_c_en_--
2014-07-01
Advertisement
Table of Contents
