Raid Controller N8103-192/193 (Aroc Type-A); Installing Raid Controller - NEC Express5800 Series User Manual

Chapter 2 Preparations
1.12

RAID controller N8103-192/193 (AROC Type-a)

RAID controller board exclusive slot is supported.
This implementation is exclusive of the 2nd riser card (N8116-72).
1.12.1

Installing RAID Controller

Please prepare the following before installing the option.
Parts included in the option kit
T-15 hexalobular driver
To install the components, follow these steps.
1. Meet the requirements described below.
 Be sure to install the additional battery (N8103-198) for the RAID controller when implementing the
RAID controller (N8103-193/201) equipped with the FBWC function.
 Connect the cable with the connector of the component in accordance with the label on the cable.
 The entire data of the server must be backed up.
2. See steps 1 to 6 in Chapter 2 (1.2 Overview of Installation and Removal) for preparations.
3. See Chapter 2 (1.9 Riser Card) for removing the Riser card.
Important
The surface becomes hot after use so to avoid burns please allow the drive
and internal parts of the system to cool before touching.
Note
In order to prevent the damage to electronic components, please start to install the
system after conducting the appropriate anti-static treatment. There is a possibility
of causing electrostatic discharge if appropriate grounding wire treatment is not
conducted.
Express5800/R120h-1E User's Guide
1. Installing Internal Optional Devices
RAID controller exclusive slot
97