Configure The Network With The Computer - Sanyo PJ-Net Organizer Plus POA-LN02 Owner's Manual

Chapter 2 Installation

Configure the network with the computer

This example explains how to set the following configuration.
IP Address
Subnet Mask
Default Gateway
DNS
The default network configuration is set as follows.
IP Address
Subnet Mask
Default Gateway
DNS
Make sure that the monitor is connected to the network and then connect the AC cord to
the outlet.
1
Temporarily* set up your computer network configuration to the same IP network number
1
as the LD-Net Organizer. For example, change your computer network configuration
as follows and restart the computer.
IP Address
Subnet Mask
Default Gateway
DNS
The network configuration of computer differs depending on each network environment
or your computer. For further information, please see the chapter "Configure the network
of computer" on page 24.
*1 Change your computer's network configuration temporarily. After completing the set up for the
monitor, you must set up again to the original network configuration for your computer. It is rec-
ommended to make a note of those network settings.

: 192.168.1.201
: 255.255.255.0
: 192.168.1.1
: 0.0.0.0
: 192.168.0.2
: 255.255.255.0
: 0.0.0.0
: 0.0.0.0
: 192.168.0.5
: 255.255.255.0
: (blank)
: (blank)