Network Configuration - Sanyo PJ-Net Organizer Plus POA-LN02 Owner's Manual

Network configuration

When you connect a monitor to a network, the network number of monitor must be the
same as the network you intend to connect. You should configure monitors network first.
Make sure that the monitor is connected to the network correctly. To configure the net-
work, use the computer. Refer to the chart below.
Procedure of Connecting the monitor to the network
Temporarily set up the computer's
network with the default network
number of the LD-Net Organizer.
Restart the Computer, if required
Using the web browser and login to
the setting page of the LD-Net
Organizer by accessing the default
IP address.
Change the network address you
want to connect to the existing
network through the setting menu
on the browser.
Restart the LD-Net Organizer
Completing the network configuration. Perform the basic
setting and operation of the monitor by using the web
browser. Please see chapter "3: Basic Setting and
Operation" on page 29 for further information.
Configure the network with computer
Reset to the computer's original
network configuration.
Installation and network configuration
p.22
Please see further
informatin on pages
22-25.
Example of computer's configuration
IP Address : 192.168.0.5
Subnet Mask : 255.255.255.0
Default Gateway : (blank)
DNS : (blank)
Please see further
informatin on pages
30-37.
Default Network Address of the
LD-NetOrganizer
IP Address : 192.168.0.2
Subnet Mask : 255.255.255.0
Default Gateway : 0.0.0.0
DNS : 0.0.0.0
Example of monitor's configuration
IP Address : 192.168.1.201
Subnet Mask : 255.255.255.0
Default Gateway : 192.168.1.1
DNS : 0.0.0.0
1
LD-NET ORGANIZER
OWNER'S MANUAL