Q&A - Sanyo PJ-Net Organizer Plus POA-LN02 Owner's Manual

Q&a
installation/access
Q
Why doesn't the setting page appear in my web browser?
A
Following causes are possible. Please check them.
1. The monitor does not connect to the network.
Check LED indicators status ( p.17).
- Check the connection of LAN cable if the LINK indicator does not illuminate
red.
- Check the network configuration of the monitor if ACT indicator does not
illuminate green.
2. Wrong network configuration of the monitor
Check the network configuration of the monitor ( p.37).
3. Wrong network configuration of the computer.
Check the network configuration of the computer.
4. The network unit is used with the default setting ( p.21).
5. The proxy setting of the web browser is not set correctly ( p.100).
6. The computer does not provide TCP/IP protocol.
Q
No setting page in my web browser? Is the problem in the network or in
the monitor? I would like to find out the problem whether it is in the net-
work or in the monitor
A
Check it by the following steps
1. Disconnect the monitor from the network and connect the monitor and com-
puter with the UTP cross cable directly.
2. Change network configuration of the computer and monitor as shown in the
example below.
(Monitor setting)
IP Address
Subnet Mask
Default gateway
DNS
(Computer setting)
: 192.168.0.2 IP Address
: 255.255.255.0 Subnet Mask
: 0.0.0.0 Default gateway
: 0.0.0.0 DNS
Q&A
: 192.168.0.5
: 255.255.255.0
: (blank)
: (blank)
LD-NET ORGANIZER
OWNER'S MANUAL
107