Table of Contents
Advertisement
Changing the remote control code
This remote control will also work with other Sanyo cameras that can be operated by infrared
remote control. Therefore, when more than one camera is present, it is recommended to change
the remote control code to ensure that only the intended camera operates when the remote
control is used. The remote control code is set to "1" at the time of purchase.
Changing the remote control code from " 1" to " 2"
1
Aim the infrared emitter at the remote control sensor
on the digital disk camera.
2
Hold down the CH button and press the W button for
more than three seconds.
œ The self-timer lamp lights for one second when the
remote control code changes to "2." Release the
buttons on the remote control.
3
Press a button on the remote control and check that the operation was carried out
correctly.
œ The remote control code is not lost even if you replace the battery in the remote control.
œ If the remote control codes for the remote control and digital disk camera do not match,
operations will not be carried out.
Returning the remote control code to " 1"
1
Aim the infrared emitter at the remote control sensor on the digital disk camera.
2
Hold down the CH button and press the T button for more than three seconds.
œ The self-timer lamp lights for one second when the remote control code returns to "1."
Release the buttons on the remote control.
Infrared emitter
CH button
CH.
T button
T
W button
W
Remote control sensor
Self timer lamp
English
38
Advertisement
Table of Contents
