3.9.4 Module and Switchgear Signal Cable Connection
Connect the signal cables for Switchgear and Module BMS's for each module.
NOTICE
Use the proper signal cables as specified by the part numbers below.
WARNING
Rack BMS / Module BMS Damage
Do not insert both ends of the signal cable WIRE ASSY MODULE TO MODULE #1 or
WIRE ASSY MODULE TO MODULE #2 into the same Battery Module.
Connect the signal cable ―WIRE ASSY RACK TO MODULE SHIELDING‖ between the switchgear
1.
―MODULE‖ connector and Module #1 ―OUT‖ connector. Pass the cable through the opening above
Module #1.
ET003222373
English 4/2018. Rev 0.0
Figure 3-72: Rack BMS to Module #1 OUT Signal Cable
.
Assembling the Product
3
63