Customising Your Keyset; Select Ring Tone; Change Your Passcode; Set Answer Mode - Samsung DCS KEYSET User Manual

Samsung DCS

Customising Your Keyset

Select Ring Tone

You can select one of eight ring tones for your keyset.
1. While on-hook, press the
2. Dial a number 1–8 or press the
hear each tone.
3. When you hear the tone that you want, press the

Change Your Passcode

By default, your extension passcode is 1234. You can change this
passcode to any 4-digit number.
1. While on-hook, press the
2. Dial your existing (old) passcode.
3. Dial a new passcode (must be four characters, e.g. 3456). You
can use numbers 0–9.
4. Redial the new passcode to verify. If successful, you will hear
two beeps. (Four beeps indicate an invalid code and you should
enter the code again.)
5. Press the
TRSF

Set Answer Mode

You can receive internal calls in one of three modes: Ringing, Auto
Answer or Voice Announce (see Answering Internal Calls in the sec-
tion 'Internal Calls' for details):
1. While on-hook, press the
2. Dial 0 for Ringing, 1 for Auto Answer or 2 for Voice Announce.
(Or use the
3. Press the
TRSF
key to store the new passcode.
Up/Down keys to select.)
VOLUME
key to store your selection.
key and dial 111.
TRSF
VOLUME
key and dial 101.
TRSF
key and dial 103.
TRSF
– 48 –
Keyset User Guide
Up and Down keys to
key.
TRSF