Remote Display - Enable/Disable - Datalogic Magellan 9300i Product Reference Manual

Enter/Exit Programming Mode
Remote Display — Enable/Disable
The scanning-scale can be configured to operate with or without a Remote Dis-
play.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You'll need to cover any
3. Complete the programming sequence by scanning the Enter/Exit Pro-
040301(CR)
Remote Display = Enable
176
Recalibration/recertification may be required when adding a
Remote Display. Consult your local Weights and Measures
authority.
If this feature is enabled the scanner will expect that it is con-
NOTE
nected to a Remote Display, and will indicate an error if one is
not. See Error Codes on page 64 in the Problem Isolation on
page 63 section for more information.
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
gramming Mode bar code.
General Scanner and Scale Features
040300(CR)
Remote Display = Disable
DEFAULT
Magellan™ 9300i / 9400i Scanners