Programming The Remote Controls To The Control Panel - CAME FAST KIT Installation Instructions Manual

5.5 - Programming the Remote Controls
To use the remote control system, proceed as follows:
A) Turn power OFF and insert AF radio frequency board then turn power back on.
B) Code the transmitter. See the relevant instruction sheet (see 5.6).
C) To store the code on the circuit board, proceed as follows:
Press and hold down the radio control save button on the radio receiver card (the signal LED will
start to flash).
At the same time transmit on one of the buttons of your remote control; keep both the top button
and the radio code save button pressed until the LED stops flashing and remains on constant. It
will then go out to indicate that the code has been successfully stored.
NB If you wish to change the code on your transmitter in the future, simply repeat the procedure
above with all the remotes on the installation.
WARNING: Disconnect the power supply from the control board before inserting OR removing the
AF radio-frequency card from the socket.
to the Control Panel
MOTHERBOARD
1 2 3 4
"AF" BOARD
20