Dell Dimension 9200 Service Manual page 45

Documentation
2. Locate the 2-pin password jumper (CLRPSWD) on the system board (see
jumper to clear the password.
NOTE: When you receive your computer, the jumper plug is attached to pins 1 and 2.
3. Replace the computer cover (see
4. Connect your computer and monitor to electrical outlets, and then turn them on.
5. After the Microsoft® Windows® desktop appears on your computer, shut down the computer (see
Computer).
6. Turn off the monitor and disconnect it from the electrical outlet.
7. Disconnect the computer power cable from the electrical outlet, then press the power button to ground the system
board.
8. Remove the computer cover (see
9. Locate the 2-pin password jumper (CLRPSWD) on the system board (see
jumper to pins 1 and 2 to re-enable the password feature.
10. Replace the computer cover (see
NOTICE: To connect a network cable, first plug the cable into the network device and then plug it into the computer.
11. Connect your computer and devices to electrical outlets, and then turn them on.
http://support.dell.com/support/edocs/systems/dim9200/en/SM_EN/syssetup.htm (9 of 11) [12/9/2007 11:19:53 PM]
Replacing the Computer Cover).
Removing the Computer Cover).
Replacing the Computer Cover).
Components), and remove the
System Board
Turning Off Your
Components) and attach the
System Board