Dell Diagnostics - Dell Dimension 9200 Service Manual

Documentation
Diskette Boot Failure
DMA Error
DMA 1 Error
DMA 2 Error
FDD Controller Failure
HDD Controller Failure
INTR1 Error
INTR2 Error
Invalid Boot Diskette
Keyboard Error
KB/Interface Error
No ROM Basic

Dell Diagnostics

http://support.dell.com/support/edocs/systems/dim9200/en/SM_EN/adtshoot.htm (7 of 11) [12/9/2007 11:19:07 PM]
Drive A or B is present but has
failed the BIOS POST.
Error in the DMA controller on
the system board.
The BIOS cannot communicate
with the floppy drive or hard
drive controller.
An interrupt channel on the
system board failed to POST.
The operating system cannot be
located on drive A or drive C.
The BIOS has detected a stuck
key.
An error occurred with the
keyboard connector.
The operating system cannot be
located on drive A or drive C.
Ensure that the drive is installed
correctly in the computer and
defined correctly in the system
setup program (see
Entering
Setup). Check the interface
System
cable at both ends.
The keyboard or system board
(see
Removing the System Board)
may need to be replaced.
Ensure that the floppy drive or
the hard drive (Installing a Hard
Drive) is installed correctly in the
computer and defined correctly in
the system setup program (see
Setup). Check the
Entering System
interface cable at both ends.
The keyboard or system board
(see
Removing the System Board)
may need to be replaced.
Enter the system setup program
(see
Entering System Setup)and
confirm that drive A or drive C is
properly identified.
Ensure that nothing is resting on
the keyboard; if a key appears to
be stuck, carefully pry it up. If the
problem persists, you may need
to replace the keyboard.
Ensure that nothing is resting on
the keyboard; if a key appears to
be stuck, carefully pry it up. If the
problem persists, you may need
to replace the keyboard.
Enter the system setup program
(see Setup) and
Entering System
confirm that drive A or drive C is
properly identified.