Diagnostic Code Indication - Honda CRF1000 Shop Manual

dummyhead dummyhead

DIAGNOSTIC CODE INDICATION

Remove the main seat (page 2-4).
Release the main harness wire clip [1] from the hole [2]
of the ETC tray.
Release the HISS 2P (Red) connector [3] from the stay
[4] of the ETC tray and disconnect it.
Connect the special tools to the wire harness side 2P
(Red) connector.
Connect the Red clip of the adaptor to the 12 V battery
positive (+) terminal and Black clip to the negative (–)
terminal.
TOOLS:
Inspection adaptor [1]
Test harness adaptor [2]
Turn the ignition switch ON with the properly registered
key and engine stop switch " ".
The HISS indicator will come on for approx. ten
seconds then it will start blinking to indicate the
diagnostic code if the system is abnormal.
The blinking frequency is repeated.
The HISS indicator remains on when the system is
normal. (The system is in the normal mode and the
diagnostic code does not appear.)
DIAGNOSTIC CODE
When the system (ECM/PCM) enters the diagnostic
mode from the normal mode:
ON
OFF
07XMZ-MBW0101
070MZ-MEC0101
BLINKING PATTERN
10 sec.
IMMOBILIZER SYSTEM (HISS)
[3]
[4]
[2]
[1]
[2]
[1]
SYMPTOM PROBLEM
ECM/PCM data Faulty ECM/PCM
is abnormal
Code signals Faulty receiver or
cannot send or wire harness
receive
Identification Jamming by the
code does not other
match transponder
Secret code does
not match
PROCEDURE
Replace the ECM/
PCM
Follow the
troubleshooting
(page 23-8)
Keep the other
motorcycle's
transponder key
away from the
immobilizer receiver
more than 50 mm
(2.0 in)
23-7