Programming Remotes
NOTE: The wireless remote that shipped with
your TEMPUR-Ergo
be paired with your base.
SINGLE BASE OR TWO BASES OPERATING
INDEPENDENTLY
STEP 1
Press and hold the LEARN button on the Control
Box. It will blink three (3) times when ready.
STEP 2
Press any button on the new remote. The LED on
the Control Box will blink two (2) times and return on
once programmed.
20
Plus is pre-programmed to
™
CUSTOMER SERVICE: 1–800–821–6621
TEMPUR-Ergo
TWO BASES OPERATING IN TANDEM BY A SINGLE
REMOTE
STEP 1
Put Remote 2 away in a safe, dry location. Take
Remote 1 and press HEAD UP button (1) to
identify Base 1 (which was paired to Remote 1 at
the factory). The base which needs to learn a new
remote is Base 2.
STEP 2
Press and hold the LEARN button on the Control
Box for Base 2 until the LED blinks three (3) times.
STEP 3
Press the LEARN button two (2) times. The LED will
turn off.
STEP 4
Press any button on Remote 1. The LED on the
Control Box will blink two (2) times and return on
once programmed.
TWO BASES OPERATING IN TANDEM BY TWO REMOTES
Follow the steps described in the previous section (Two
Bases Operating in Tandem by a Single Remote)
using Remote 2 and Base 1.
Plus
™
Need help?
Do you have a question about the TEMPUR-ERGO PLUS and is the answer not in the manual?
Questions and answers