Related Manuals for Tempur-Pedic TEMPUR-ERGO PLUS
Summary of Contents for Tempur-Pedic TEMPUR-ERGO PLUS
- Page 1 TEMPUR‑Ergo Plus ™ Complete Reference Guide Patents pending TEPL-100-04 © 2014 Tempur-Pedic Management, LLC. All Rights Reserved.
- Page 2 This two (2) year Warranty shall not apply if purchaser does TEMPUR-PEDIC UNDERTAKES NO RESPONSIBILITY FOR THE not return any and all defective parts to Tempur-Pedic within 15 days of QUALITY OF THE GOODS EXCEPT AS OTHERWISE PROVIDED IN THIS purchaser’s receipt of replacement part.
- Page 3 ADDITIONAL TERMS AND CONDITIONS The decision to repair or to replace defective parts under this Limited Warranty shall be made by Tempur-Pedic at its option and at its sole In no instance will this warranty cover any damage attributable to misuse discretion.
-
Page 4: Table Of Contents
TEMPUR-Ergo Plus ™ Table of Contents SAFETY PRECAUTIONS ....................5 COMMONLY ASKED QUESTIONS AND ANSWERS ............. 9 SPECIFICATIONS ......................10 INSTALLATION Installation Instructions ..................11 Pre-Delivery Procedure ..................12 Delivery Procedure ....................13 Headboard Installation ................... 15 OPERATION Wireless Remote Control Features ................. 17 Operating Instructions .................... -
Page 5: Safety Precautions
When using an electrical furnishing, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING YOUR TEMPUR-ERGO PLUS. DANGER To reduce the risk of electric shock: • Always unplug this furnishing from the electrical outlet before cleaning. - Page 6 (with the exception of the battery compartments). The warranty is void if these units are tampered with. Any repair or replacement of TEMPUR-Ergo Plus parts must be performed by an authorized service person. IN-HOME USE AND HOSPITAL DISCLAIMER Your TEMPUR-Ergo Plus is strictly designed for in-home use only.
- Page 7 In order to prevent the movement of this product with casters, all four casters should be in the locked position. Your TEMPUR-Ergo Plus has been designed to This can be accomplished by pushing down the locking provide you with the reliable operation and durability latch on the caster.
- Page 8 NOTE: Exceeding the recommended weight restrictions could damage your TEMPUR-Ergo Plus and void your warranty. For best performance, you should enter and exit the TEMPUR-Ergo Plus while it is in the flat or fully lowered position. CUSTOMER SERVICE: 1–800–821–6621...
-
Page 9: Commonly Asked Questions And Answers
TEMPUR-Ergo Plus will fit. Please refer to is approximately 12 inches. See chart on page 10 for the specifications on page 10 for dimensions of the base. -
Page 10: Specifications
TEMPUR-Ergo Plus ™ Bed Type A. Base B. Base Weight Width Length Specifications Twin 37.8" 74.8" 114 lb Twin Long 37.8" 78.8" 117 lb Double 53.2" 74.8" 154 lb Queen 58.3" 78.8" 163 lb Split CA King 35.8" 82.7" 119 lb 12"... -
Page 11: Installation
Installation Installation Instructions Before discarding any packing materials, check your TEMPUR-Ergo Plus carton and verify the following ™ *Attached to base for shipping. items in the parts list are included: Appearance of some parts may differ from photos. PARTS LIST A. -
Page 12: Pre-Delivery Procedure
TEMPUR-Ergo Plus ™ Pre‑Delivery Procedure STEP 1 STEP 6 Lift carton top off box to reveal the bottom Once the warehouse test is successful and complete: of the base. • Unplug the power extension cord • Remove the batteries from the remote control and STEP 2 power supply and return both to the accessory Using a power extension cord to reach the base,... -
Page 13: Delivery Procedure
Carefully take base in the carton to the bedroom and place next to where the customer wants it set up. STEP 2 Carefully lift the TEMPUR-Ergo Plus out of the shipping carton, keeping the unit topside down. Install (2) 9-Volt batteries into the battery For safety reasons, this should be performed by compartment of the power supply. - Page 14 TEMPUR-Ergo Plus ™ STEP 6 STEP 7C Carefully flip the TEMPUR-Ergo Plus over to the Start with the right side and insert two (2) Retainer ™ topside up position. Bar Bolts (F) through the holes of the Retainer Bar Plate (E) through the opening in the Mattress NOTE: Make sure to lift the adjustable base off Retainer Bar (D) to the base.
-
Page 15: Headboard Installation
Headboard Bracket such that a distance of D. 5/16 Inch Washer (12) approximately 1 1/2 inches to 2 inches exists E. 5/16 Inch Locking Nut (6) between the edge of the TEMPUR-Ergo Plus and the F. Wrench (1) Headboard Bracket assemblies. G. Allen Wrench (1) - Page 16 Headboard Bracket assemblies. mattress is no more than 3 inches. STEP 2 Your TEMPUR-Ergo Plus installation is now complete. Attach your headboard to the Headboard Brackets Refer to the Wireless Remote Control Features on the following the steps below: following pages for additional usage instructions.
-
Page 17: Operation
Operation Wireless Remote Control Features READ ADVISORY INFORMATION IN THE SAFETY PRECAUTIONS SECTION OF THIS GUIDE CAREFULLY BEFORE USING THIS PRODUCT. THE POTENTIAL FOR ELECTRIC SHOCK EXISTS IF ELECTRICAL COMPONENTS ARE NOT INSTALLED OR OPERATED PROPERLY. 1. HEAD UP (HU) 3. -
Page 18: Operating Instructions
TEMPUR-Ergo Plus ™ Operating Instructions To ensure safe operation of the system, please observe the following safety instructions: CAUTION: Keep children away from electrically adjustable beds and control units. There is risk of injury and electric shock. CAUTION: Unplug the power cord during a thunderstorm or if you do not intend to use the system for an extended period of time. -
Page 19: Special Functions
Special Functions System Reset Emergency Power‑Down This function resets the system to the zero position. The two (2) 9-Volt batteries in the power supply give the user the possibility to move the bed to a flat position A reset may be required in the following cases: during power failure. -
Page 20: Programming Remotes
TEMPUR-Ergo Plus ™ Programming Remotes TWO BASES OPERATING IN TANDEM BY A SINGLE REMOTE NOTE: The wireless remote that shipped with STEP 1 your TEMPUR-Ergo Plus is pre-programmed to ™ Put Remote 2 away in a safe, dry location. Take be paired with your base. -
Page 21: Change From Tandem System To Single System
Advanced Remote Control Programming Change from a Tandem System to a Single System This function will separate a Tandem System, resulting in two Single Systems. This will allow each base to be individually controlled by their respective remotes. STEP 1 Perform System Reset on page 19 for Remote 1 and Base 1. -
Page 22: Troubleshooting
Blue LED Backlight will not illuminate. • Ensure the batteries are installed correctly. NOTE: Do not mix old and new batteries. • The TEMPUR-Ergo Plus may be obstructed. Elevate and check for an obstruction. Remove the obstruction. Head and/or Leg section will elevate •... - Page 23 Troubleshooting SYMPTOM SOLUTION • Check batteries in Wireless Remote Control, replace with two (2) new AA batteries if necessary. NOTE: Do not mix old and new batteries. • Make sure that you are following the duty cycle of the motors (do not operate more than 2 minutes over a 20-minute period, Head and/or Leg lift function has minor or approximately 10% duty cycle).
- Page 24 Serial Number: Write Serial Number here for future reference. FOR TECHNICAL SUPPORT OR SERVICE, QUESTIONS ABOUT YOUR TEMPUR-PEDIC MATTRESS, ® OR TO ORDER TEMPUR-ERGO PLUS ACCESSORIES: ™ 1-800-821-6621 OR VISIT WWW.TEMPURPEDIC.COM 9064-TEM...
Need help?
Do you have a question about the TEMPUR-ERGO PLUS and is the answer not in the manual?
Questions and answers