Configuring A Vnc Connection - GE moisture.iq User Manual

Chapter 6. Setting Up Communications

6.5 Configuring a VNC Connection

IMPORTANT: The VNC
Note: The moisture.IQ system cycle time may be increased by VNC usage.
A Virtual Network Console ( VNC ) connection allows remote access to the moiture.IQ by replicating the
touchscreen on a PC monitor, tablet or smart phone. To configure a VNC connection, complete the following
steps:
1. From the Configuration Menu screen (see Figure 52 on page 59), tap the VNC button to open a VNC
Setup screen similar to Figure 72 below.
2. If the VNC Server button indicates that the VNC Server is currently Enabled , tap this button to Disable
the VNC Server (changes to the settings can only be made when the VNC Server is Disabled ).
3. Tap the Listen on Port button and enter the appropriate Port Number. Then, tap the Check button to
save the value and tap the Return button to return to the VNC Setup screen. In most cases, the default
Port 5900 should be used.
Note: The Password and Accept Connections From buttons are not functional in this software version.
When a VNC client connection is established, the analyzer will display a Log In prompt. Log in using the
credentials for the Admin , Operator or additional account that is configured to permit VNC connections. After a
VNC connection has been established, the analyzer will display a "flashing eye" cursor
remote user's actions. This indicates to a local user that a remote user is connected. When the remote user
disconnects, the "flashing eye" cursor is removed.
1 VNC®
is a registered trademark of
82
1
connection opens port 5900 (user-configurable) when Enabled .
Figure 72: VNC Setup Screen
RealVNC Ltd
that tracks the
moisture.IQ User's Manual