Configuring The Web Server - GE moisture.iq User Manual

6.6 Configuring the Web Server

IMPORTANT: The Web Server opens Port 80 when it is Enabled .
The moisture.IQ can be remotely accessed using a web browser by enabling the Web Server. To configure the
Web Server , complete the following steps:
1. From the Configuration Menu screen (see Figure 52 on page 59), tap the Web Server button to open a
Web Server Setup screen similar to Figure 73 below.
2. If the Web Server button indicates that the Web Server is currently Enabled , tap this button to Disable
the Web Server (changes to the settings can only be made when the Web Server is Disabled ).
3. Tap the Port button and enter the appropriate Port Number. Then, tap the Check button to save the
value and tap the Return button to return to the Web Server Setup screen. In most cases, the default
Port 80 should be used.
4. Tap the Web Server button so that it indicates that the server is either Enabled or Disabled , as desired.
5. After the Web Server status has been configured as desired, tap the Return button to return to the
Configuration Menu.
When the Web Server is Enabled , it can be used to monitor the instrument status and to perform file
downloads.
moisture.IQ User's Manual
Figure 73: Web Server Setup Screen
Chapter 6. Setting Up Communications
83