GE 169 Instruction Manual page 58

3 SETUP AND USE
3$*( '(6&5,37,21
5
ENTER STOPPED
COOL TIME = XXX MINUTES
Not seen if cooldown time learned values are used. This code is seen when the learned motor cooling
times are not used by the 169. This value represents the time for the thermal memory to discharge from
100% to 0% with the motor stopped. The OVERLOAD TRIP lockout time is 85% of this value (see
section 3.20).
5-135 - cooling time in minutes. Factory Value = 30
5
RTD 8 AMBIENT SENSOR ?
XXX
or
RTD10 AMBIENT SENSOR ?
XXX
(RTD 8 – model 169; RTD 10 – model 169 Plus). This code is used to select one of the bearing RTDs as
an ambient air temperature sensor. When stored as YES, trip and alarm levels for the selected RTD will
be automatically set to "OFF". See section 3.20.
YES - Indicated RTD will be used for ambient air temperature measurement
NO - Indicated RTD will be used for other (non-stator) temperature measurement
Factory Value = NO
5
DEFEAT SPEED SWITCH?
XXX
(model 169 Plus only) This setpoint is used to defeat or enable the Speed Switch Trip.
YES - Speed Switch function disabled, no speed switch used
NO - Speed Switch function enabled, speed switch can be used
Factory Value = YES
5
SPEED SWITCH
TIME DELAY = XXX.X SEC.
Not seen if speed switch function is disabled (model 169 Plus only). This setpoint is used to set the time
delay for the operation of the speed switch function.
0.5-100.0 (increments of 0.5) - time delay in seconds; Factory Value = 2.0
5
ANALOG OUTPUT PARAMETER
= XXXXXXXXXXXXXX
This setpoint is used to select the analog current output function.
Thermal Memory - Motor thermal capacity used
Motor Load - Motor current as a percentage of full load
Max Stator RTD - Hottest stator RTD temperature (0-200 C)
CT secondary - CT secondary current as a percentage of CT secondary amps rating
Factory Value = Max Stator RTD
g
52
GE Power Management