Module mounting
The following shows the procedure to mount the module. In this procedure, mount the target module on the base unit. This
procedure is common among all the modules.
In direct change, control is immediately started after the module is mounted. Thus, after mounting a terminal block and
connectors to the module, check that the system does not malfunction and mount the module.
Module mounting
Connect the terminal block and connecters
*1
to the new module.
Do not supply external
power supply to the module here.
Mount a new module on the same slot.
To "Module recognition"
*1 Insert the SD memory card (which was removed when the module was removed) to a new module, if MES interface module, high speed
data logger module, C intelligent function module, and OPC UA server module are used.
*2 If mounting a module fails, an error may occur at module recognition. Remove and mount the module again.
*2
3 REPLACEMENT PROCEDURE
3.5 Changing a Module Directly
3
45