Table of Contents
Advertisement
Settings
Settings
Security settings
Display the <Security> screen.
On the Home screen, touch as follows:
Then, on the <SETUP> screen, touch [Security].
<Security Code Set>
Register the security code for the unit. (Page 5)
<Security Code Cancellation>
Clear the security code. (Page 5)
<Security Code Change>
Change the security code. (Page 5)
Remote Controller
Remote Controller
Optional remote controller KNA-RCDV331 is designed
for controlling this unit. Refer to the instruction manual
that comes with the remote controller.
CAUTION
• Put the remote controller in a place where it will
not move during braking or other operations. A
dangerous situation could result if the remote
controller falls down and gets wedged under the
pedals while driving.
• Do not leave the battery near fire or under direct
sunlight. A fire, explosion or excessive heat
generation may result.
• Do not recharge, short, break up or heat the battery,
or place it in an open fire. Such actions may cause
the battery to leak fluid. If spilled fluid comes in
contact with your eyes or clothing, immediately rinse
with water and consult a physician.
• Place the battery out of reach of children. In the
unlikely event that a child swallows the battery,
immediately consult a physician.
Preparation
Battery installation
Use two "AAA"/"R03"-size batteries.
Insert the batteries with the + and – poles aligned
properly, following the illustration inside the case.
• Always insert batteries from – poles to avoid bending
the springs.
• If the remote controller operates only over shorter
distances or does not operate at all, it is possible that
the batteries are depleted. In such instances, replace
both batteries with new ones.
ENGLISH
35
Advertisement
Table of Contents
