Camera Settings - Kenwood DMX6018BT Instruction Manual

Monitor with receiver
Hide thumbs Also See for DMX6018BT:
Table of Contents

Advertisement

Settings
Settings
<Beep>*1
• ON (Initial): Activates the key-touch tone.
• OFF: Deactivates the key-touch tone.
<Language Select>
Select the text language used for on-screen
information. For details, see "Initial settings" on
page 5.
<Touch Panel Adjust>
Adjust the touch positions of the buttons on the
screen.
Touch and hold the center of the marks at the lower
left (1), then the upper right (2) as instructed.
(Hold)
• To reset the touch position, touch [Reset].
• To cancel the current operation, touch [Cancel].
<Clock>
Select the method to set the date and clock. For
details, see "Calendar/clock settings" on page 6.
<Time Zone>*2
Select the time zone for your area. For details, see
"Calendar/clock settings" on page 6.
<Clock Adjust>*2
Adjust the date and clock manually. For details, see
"Calendar/clock settings" on page 6.
*1 Available only when <X'over Network> is set to [2way].
*2 Available when [Clock] is set to [Manual].

Camera settings

Display the <Camera> screen.
On the Home screen, touch as follows:
(Hold)
Then, on the <SETUP> screen, touch [Camera].
<R-CAM Interruption>
• ON: Displays the picture from the rear view camera
when you shift the gear to the reverse (R) position.
• OFF (Initial): Select this when no camera is
connected.
<R-CAM for Car interface>
• ON: Selects when you connect an external system
unit. (Neither buttons nor titles are displayed.)
• OFF (Initial): Selects when a rear view camera is
connected.
<Parking Guidelines>
• ON (Initial): Displays the parking guidelines.
• OFF: Hides the parking guidelines.
<Guidelines Setup>
Adjust the parking guidelines according to the size of
the car, parking space and so on.
When adjusting the parking guidelines, make sure to
use the parking brake to prevent the car from moving.
Touch one of the
marks (1), then adjust the
position of the selected
mark (2).
Initialise
Make sure that A and B are horizontally parallel, and
that C and D are the same length.
• Touch [Initialise] to set all the marks to the initial
default position. A confirmation message appears.
Touch [Yes].
ENGLISH
33

Advertisement

Table of Contents
loading

Table of Contents