Canon iP4700 Simplified Service Manual page 4

LED
(Blinking in Error
orange)
10 times Automatic duplex
printing cannot be
performed.
11 times Failed in automatic print
head alignment.
13 times The remaining ink
amount unknown.
14 times Ink tank not recognized. [1684]
15 times Ink tank not recognized. [1682]
Error
Solution
code
[1310] The paper length is not supported
for duplex printing.
Press the Resume/Cancel button
to eject the paper being used at
error occurrence.
Data which was to be printed on
the back side of paper at error
occurrence is skipped (not
printed).
[2500] Press the Resume/Cancel button
to clear the error, then perform the
automatic print head again.
(In the iP4700 / iP4760, use Matte
Photo Paper MP-101.)
[1683] Replace the applicable ink tank
with a new one. Printing with a
once-empty ink tank can damage
the printer.
To continue printing without
replacing the ink tank(s), press
the Resume/Cancel button for 5
sec. or longer to disable the
function to detect the remaining
ink amount. After the operation, it
is recorded in the printer
EEPROM that the function to
detect the remaining ink amount
was disabled.
A non-supported ink tank (an ink
tank that is sold in a different
region from where the printer was
purchased) is installed (the ink
tank LED is turned off). Install the
supported ink tanks.
A hardware error occurred in an
ink tank (the ink tank LED is
turned off). Replace the ink
tank(s).
(4/24)
Remarks
Data which was to be
printed on the back
side of paper at error
occurrence is not
printed.
The ink tank installed
is judged to have once
been empty.