Page 1
Continuous Ink Supply System CANON PIXMA IP4200 Installation Instruction For DP Prefilled Version With Original Chips This Version of the Continuous Ink Flow System comes with Prefilled Cartridges and Auto Reset Chips. You just need to fill the Reservoir bottles and print! The whole operation is very easy. It’...
Page 2
CIS for CANON PIXMA IP4200 Instruction Thank you for purchasing DP Continuous Ink Supply System. We appreciate your support and will try our best to make your experience with our products a pleasant one. Printing has been a different experience ever since you installed DP Continuous Ink Supply system on your own printer. Just imagining being able to print without regard to the ink level in those expensive little cartridges.
3. Installation Procedures: 1) First step Put the CIS at the right side of printer Take off the rubbers from ink tank’s Put the Air-filter into the Air-hole And make sure the tube line does not Air-hole twist. 2) Install chips Carefully remove the original chips Pay attention when you remove original Finished.
Page 4
4) Install the tubing. Clip the tube into the support arm as the pictures shown. 5) Adjust tubing Adjust the tube length and move from Please make sure there will be no block Ensure the length of tube so that Left to right for several times.
Page 5
If it shows any breaks (maybe it caused by air bubbles in the printing head), please clean your printing head. If it still shows little breaks, especially only for one color, it is unnecessary to repeatedly clean printer-head. Just keep the printer unusing for about one hour and print a Demo Page again.
Page 6
Pls pay attention to the ink level .If it is Take off the ink tank’s rubber slowly Refill ink according to the color carefully less than 1cm of ink tank, then use refill And clean the ink tanks after refilling. kits to refill at once.