Canon iP4700 Simplified Service Manual page 3

LED
(Blinking in Error
orange)
5 times
Print head not installed,
or not properly installed.
Faulty print head ID.
Print head temperature
sensor error.
Faulty EEPROM data of
the print head.
6 times Inner cover error.
Time-out in CD / DVD
print operation.
7 times Multiple ink tanks of the
same color installed.
Ink tank in a wrong
position.
8 times Warning: The ink
absorber becomes
almost full.
9 times The connected digital
camera or digital video
camera does not support
Camera Direct Printing.
Error
Solution
code
[1401] Install the print head properly.
Re-set the print head. If the error
is not cleared, the print head may
[1403]
be defective. Replace the print
head.
[1405]
*2
[1841 , Close the inner cover, and press
*2
1846 , the Resume/Cancel button.
*1
1851 ,
*1
1856 ]
*1
[1850 , Open the inner cover, place the
*1
1855 ] CD-R tray and press
Resume/Cancel.
*1
[1830 ] A prescribed period of time (12
minutes) has elapsed without any
printing since printing was
attempted. Press the
Resume/Cancel button to clear
the error.
[1487] Replace the wrong ink tank(s)
with the correct one(s).
[1680] Install the ink tank(s) in the correct
position.
[1700/ Replace the ink absorber, and
1701] reset its counter. [See 2-2.
Adjustment / Settings, (4) Service
mode]
Pressing the Resume/Cancel
button will exit the error, and
enable printing without replacing
the ink absorber. However, when
the ink absorber becomes full, no
further printing can be performed
unless the applicable ink absorber
is replaced.
[2001] Remove the cable between the
camera and the printer.
(3/24)
Remarks
The error "The ink
absorber becomes
almost full (service
call)" may occur soon.