Sanyo MCO-18AIC Service Manual page 54

PRECAUTIONS FOR SAFE OPERATION
CAUTION
Select a level and sturdy floor for installation. This precaution will prevent the unit from tipping.
Improper installation may result in water spillage or injury from the unit tipping over.
Connect the unit to a power source as indicated on the rating label attached to the unit. Use
of any other voltage or frequency other than that on the rating label may cause fire or electric shock.
When removing the plug from the power supply outlet, grip the power supply plug, not the cord.
Pulling the cord may result in electric shock or fire by short circuit.
Never damage or break the power supply plug or cord. Do not use the supply plug if its cord
is loose. This may cause fire or electric shock.
Do not touch any electrical parts such as the power supply plug or any switches with a wet
hand. This may cause electric shock.
Do not put a container with water or heavy articles on the unit. It may cause injury if the articles
fall. Current leakage or electric shock may result form deterioration of insulation by spilled water.
Do not climb onto the unit and do not put articles on the unit. This may cause injury by tipping
or damage to the unit. When stacking the unit, follow the procedure shown on page 33.
Always hold the handle when closing the door. This will reduce the likelihood of a trapped finger.
Do not damage the power supply cord. Stepping on the cord, or processing, pulling, twisting, or
binding of cord may cause fire or electric shock by damaged cord.
Never lean or press on the glass or never hit the glass with sharp edge. Intentional force may
cause injury if the glass breaks.
Do not lean on the door. This may cause injury, current leakage, or electric shock if the unit tips
over or door becomes detached.
Always put on gloves at the time of maintenance. The corners of fixtures may cause injury.
Disconnect the power supply plug before moving the unit. Take care not to damage the power
cord. A damaged cord may cause electric shock or fire.
Empty the humidifying pan completely before moving the unit. Spilled or splashed water may
cause current leakage or electric shock.
51
5