6. Replace the duct. Place the humidifying tray,
then cover the tray with the humidifying tray
cover as shown in Fig. 5
Humidifying tray cover
7. Replace the insulation into the UV lamp lead wire
hole with the wire passed through the cut on the
insulation. See Fig.6
UV lamp
lead wire
Insulation
Fig.5
Fig.6
33
8. Remove a cap shown in Fig. 7.
By using 4 screws enclosed with this kit,
fix the ballast/glow assy as shown in Fig. 7.
Screw
ballast & glow assy
Cap
Fig.7