Commissioning; Parameters; General - ABB 2CSYK1102C/S Product Manual

MYLOS Building Automation
®
2

Commissioning

The main functions of the 2CSYK110xx Switch Actuators are described in this section.
The 16A Switch Actuator parametrisation is performed via the Engineering Tool ETS Software application program.
For the parametrisation you need a pc desktop or a laptop with ETS and connection to the KNX system (obtainable
for example by means of RS232, USB or IP Interface).
The Switch Actuators 2CSYK110xx offer the same functions and the same user interface. Therefore it is possible to
set each output freely depending on the application and to configure it accordingly.
2.1

Parameters

2.1.1

General

Do you wish to limit the number of telegrams?
It is possible to define the maximum number of unchanged telegrams during a time interval. This parameter is
important upon bus voltage restoration since many devices can send their status at the same time.
Maximum number of telegrams every 10 seconds (if you wish to limit the telegram number it is set on Yes)
Maximum number of telegrams that can be sent by the device within 10 seconds.
Sending and switching delay after bus voltage restoration in [2..255] s
The delay determines the time that elapses between bus voltage restoration and the first moment in which telegrams
can be sent and the relay can be switched. Initialisation time – reaction time of about 2 seconds until the processor
is fully operation – it is already included in the delay time.
Reaction upon voltage failure
Through this parameter, the output can assume a definite status when a bus voltage failure occurs.
The following operation modes are available:
10 Commissioning | MYLOS Building Automation
®
Commissioning