Chapter 3
Lift and Mount the Drive
Release Drive Assembly from
Cabinet
124
To access the interior of the drive cabinet to complete installation and power
wiring connections, remove the drive assembly from the cabinet.
IMPORTANT Before removing the drive assembly, be sure that the cabinet is in its
intended installed position. Height adjustments to the roll-out cart cannot
be made while carrying a drive.
1. Open the cabinet door.
2. Remove the side shields (see number 4 in
3. Remove the bus bar connector bolts (see numbers 1, 2, and 3 in
88).
4. Disconnect the two captive bolts that connect the converter chassis to
the exhaust vent (see number 5 in
5. Disconnect the four captive bolts that connect the converter chassis to
the cabinet frame (see number 6 in
IMPORTANT When removing both the inverter and converter drive sections from
6. Disconnect the six captive bolts that connect the inverter chassis to the
cabinet frame (see number 7 in
Rockwell Automation Publication 750-IN001P-EN-P - April 2017
Figure
Figure
89).
Figure
89).
the cabinet, do not disconnect the captive bolts that hold the two
sections together. The inverter-to-converter connector bolts are
labeled number 8 in
Figure
89.
Figure
89).
88).
Figure