Operation - Makita DLS714 Instruction Manual

means of supporting workpieces horizontally.
Install them on the side of the tool, then tighten the
1
2
1. Holder 2. Holder assembly
When cutting long workpieces, use the holder-rod
assembly (optional accessory). It consists of two holder
assemblies and two rods 12.
2
1. Holder assembly 2. Rod 12

OPERATION

WARNING:
Make sure the blade is not con-
tacting the workpiece, etc. before the switch
is turned on. Turning the tool on with the blade in
contact with the workpiece may result in kickback and
WARNING:
After a cutting operation, do not
raise the blade until it has come to a complete
stop. The raising of a coasting blade may result in
WARNING:
Do not touch the clamp screws
which secure the slide poles while the saw blade
is rotating. Otherwise the tool may lose control and
NOTICE:
handle from the lowered position by pulling the
stopper pin.
NOTICE:
handle when cutting. Too much force may result in
decrease in blade speed.
NOTICE:
form the cut. If the handle is pressed down with force
or if lateral force is applied, the blade may vibrate and
leave a mark (saw mark) in the workpiece and the
precision of the cut may be impaired.
NOTICE:
carriage toward the guide fence without stopping.
If the carriage movement stops during the cut, a mark
may be left in the workpiece and the precision of the
cut may be impaired.
Press cutting (cutting small
workpieces)
which secure the slide poles clockwise so that
the carriage will not move during operation.
possible kickback which may result in serious per-
1
Workpieces up to 52 mm high and 97 mm wide can be
cut in the following manner.
1.
tighten two clamp screws which secure the slide poles
clockwise to secure the carriage.
2.
3.
contact and wait until the blade attains full speed before
lowering.
4.
tion to cut the workpiece.
5.
wait until the blade has come to a complete stop
before returning the blade to its fully elevated position.
17 ENGLISH
Before use, be sure to release the
Do not apply excessive pressure on the
Gently press down the handle to per-
During a slide cut, gently push the
WARNING:
Firmly tighten two clamp screws
Gently lower the handle to the fully lowered posi-
When the cut is completed, switch off the tool and
-