Makita DLS714 Instruction Manual page 10

"Installing or removing saw blade".
cover and tighten the hex socket bolt.
1. Make sure that the tool is switched off and the
battery cartridges are removed.
2. Turn the hex socket bolt counterclockwise using
the supplied hex wrench with holding the center cover.
3. Raise the blade guard and center cover.
4. When cleaning is complete, return the center
cover and tighten the hex socket bolt by performing the
steps above in reverse.
WARNING:
Do not remove spring holding blade
guard.
light exposure, contact a Makita service center for replace-
ment. DO NOT DEFEAT OR REMOVE GUARD.
Positioning kerf board
This tool is provided with the kerf boards in the turn base to
minimize tearing on the exit side of a cut. The kerf boards are
1. Make sure to remove the battery cartridge. Then, loosen all
the screws (2 each on left and right) securing the kerf boards.
2
1
1. 2.
2. Re-tighten them only to the extent that the kerf
boards can still be easily moved by hand.
3. Lower the handle fully and push in the stopper pin
to lock the handle in the lowered position.
4. Loosen two clamp screws which secure the slide poles.
1
1. Thumb screw
5.
6.
contact the sides of the blade teeth.
3
1.
bevel cut 5.
7.
8.
2
tact the sides of blade teeth.
9.
10.
per pin and raise the handle. Then tighten all the screws
securely.
NOTICE:
that the kerf boards are adjusted properly. Correct
support of the workpiece and minimizing workpiece
tear out.
Maintaining maximum cutting
capacity
1
cutting capacity for a 190 mm saw blade.
When installing a new blade, always check the lower
follows:
1. Remove the battery cartridge. Then, push the car-
riage toward the guide fence fully and lower the handle
completely.
10 ENGLISH
1 1
2
4
2. Blade teeth 3.
After setting the bevel angle ensure
2
3
5
4. Left
-
-