Main Menu - View Information; Main Menu - Change Settings - ABB CDD Product Manual

MAIN menus
Statistics of the system and each inverter
View Information read only display
PN of the CDD
SN of the CDD
Firmware Rel. > press ENTER to view
Application FW
Bootloader FW
Wless Firmware
RF Firmware
Date
Time
Events, Alarms Present >
or NO alarms >press ENTER to view log of alarm codes listed by date
and time, identified as CDD or MIC (inverter) serial number
Change Settings modify CDD settings and acquire inverters
Change Language > of the CDD, press ENTER and select language from the list
Set Date/Time > of the CDD, press ENTER to change
Automatic: Yes scroll to NO and press ENTER to change
Set Time Zone > of the CDD, press ENTER to change
Set Time Zone scroll UP/DOWN, press ENTER to select
GMT: +/- XX.XX scroll UP/DOWN, press ENTER to select
Display Timeout > press ENTER to change display timeout, 1 to 10 minutes or Off
Network, Change locked! Wireless network is enabled by default and locked.
To change to Ethernet, wireless must first be disabled from BASIC menu
Network > once wireless is disabled, press ENTER to change to Ethernet
Reset Ground Fault ?
Geo Position > of the plant, press ENTER to change, use UP/DOWN to enter
Lat:/Long: N/S xx.xx, E/W xx.xx
Country STD > grid/country standard of the inverters, press ENTER and scroll
Remote update > press Enter to check for available updates
No Update Avail., Check Now? >
Micro Manager
[Add] Inverters > press ENTER to acquire inverters, GEO position and
timezone will display and always need to be entered for acquisition to start
[ST] Inverters > scroll DOWN list of inverters, press ENTER to view status
[Kll] Inverters > to remove individual inverters from the CDD, press DOWN
DST: NO scroll to YES to select daylight savings time if applicable
Enter date/time using UP/DOWN, press ENTER to accept change
Reset, Are you sure? press ENTER to reset
latitude and longitude, press ENTER to accept change
through the list of available grid standards, press ENTER to select
Check for update, waiting . . . . .
Lat:/Long: > use UP/DOWN to enter coordinates, ENTER to accept
Set Timezone > use UP/DOWN to enter timezone, ENTER to accept
Scanning .... for inverters will begin after GEO position and timezone
are entered (see acquisition process in part 5)
to scroll inverters identified by number, MAC and serial number
[03]MAC: XXXXXXXX, SN:XXXXXX press ENTER to select inverter
*** Kill > press ENTER to remove inverter from CDD
- 25 -
4 - CDD display operations
M
ain menu - View
information
M
ain menu - Change
settings