Safety; Electrical Safety; Symbols; Health & Safety - ABB 4690 User Manual

4690 Series
Turbidity systems

1 Safety

Information in this manual is intended only to assist our customers in the efficient operation of our equipment. Use of this manual for
any other purpose is specifically prohibited and its contents are not to be reproduced in full or part without prior approval of the
Technical Publications Department.

1.1 Electrical Safety

This equipment complies with the requirements of CEI/IEC 61010-1:2001-2 'Safety Requirements for Electrical Equipment for
Measurement, Control and Laboratory Use' and complies with US NEC 500, NIST and OSHA.
If the equipment is used in a manner NOT specified by the Company, the protection provided by the equipment may be impaired.

1.2 Symbols

One or more of the following symbols may appear on the equipment labelling:
Warning – Refer to the manual for instructions
Caution – Risk of electric shock
Functional earth (ground) terminal
Protective earth (ground) terminal
1.3 Health & Safety
Health and Safety
To ensure that our products are safe and without risk to health, the following points must be noted:

The relevant sections of these instructions must be read carefully before proceeding.

Warning labels on containers and packages must be observed.

Installation, operation, maintenance and servicing must be carried out only by suitably trained personnel and in accordance
with the information given.

Normal safety precautions must be taken to avoid the possibility of an accident occurring when operating in conditions of
high pressure and / or temperature.
Safety advice concerning the use of the equipment described in this manual or any relevant hazard data sheets (where
applicable) may be obtained from the Company address, together with servicing and spares information.

1.4 Product Disposal

Note. The following only applies to European customers.
ABB is committed to ensuring that the risk of any environmental damage or pollution caused by any of its products is
minimized as far as possible. The European Waste Electrical and Electronic Equipment (WEEE) Directive (2002/96/EC)
that came into force on August 13 2005 aims to reduce the waste arising from electrical and electronic equipment; and
improve the environmental performance of all those involved in the life cycle of electrical and electronic equipment.
In conformity with European local and national regulations (EU Directive 2002/96/EC stated above), electrical equipment
marked with the above symbol may not be disposed of in European public disposal systems after 12 August 2005.
2
Direct current supply only
Alternating current supply only
Both direct and alternating current supply
The equipment is protected through double insulation
1 Safety
IM/4690–EN Rev. A