Advertisement
1. Switch on the mains power supply of
the free@home wireless devices
à The devices are now in programming
mode for 30 minutes
2. In the user interface of the System
Access Point select „System settings
-> Search for free@home wireless ->
devices"
à The System Access Point now consec-
utively scans all free@home wireless
channels. Devices that are in program-
ming mode are integrated automati-
cally into the system. The scanning
process ends 10 minutes after the last
device has been found.
3. Integrated devices are listed in the
„Device list" of the user interface. Use
the serial numbers to check whether
all installed devices have been found.
4. If a device has not been found, it may
not have been in programming mode.
The reason for this could be that
a. the programming time has expired
b. the device has already been coupled
with a different system
Reset the device to the factory settings
and start a new scanning process
Resetting to factory setting
1. De-energize the free@home wireless
device
2. Keep the button at the bottom left
pressed
3. Re-energize the device
à The LED flashes slowly for 10 sec-
onds, then fast for 5 seconds and
then goes out
à The factory settings have been
restored and the device can now be
programmed again
Note: Devices which are already in fac-
tory settings are not reset again. The
LED remains out in step 3.
Note: The development of free@home
is continuous in order to offer you new
functions or to rectify errors.
Pay us a visit at www.busch-jaeger.com
to inform yourself about current updates,
or register your system at my.abb-living-
space.com to be automatically informed
about new software updates and to test
the free@home remote control for one
month at no charge.
free@home | 09
Advertisement
