Table of Contents
Advertisement
A. Lower crankcase
B. Upper crankcase
TIP
Connecting rod bolt
1. Lubricate the connecting rod bolts threads and connecting rod nuts mating surface with molybde-
num disulfide oil.
2. Tighten the connecting rod bolts to 15 Nm (1.5 m·kgf, 11 ft·lbf), and then tighten them further to reach
the specified angle 145–155°.
EAS30017
CHASSIS TIGHTENING TORQUES
Item
Engine mounting nut (rear upper
side)
Sidestand bolt
Engine mounting nut (rear lower
side)
Engine mounting bolt (right front
side)
Engine mounting bolt (left front side)
Engine bracket bolt (right)
Engine bracket bolt (left)
Engine mounting bolt (right upper
side)
Engine mounting bolt (left upper
side)
Rider seat bolt
Center cover screw
B
×3
×3
19
18
17
16
15
Thread
Q'ty
size
M10
1
M10
2
M10
1
M10
1
M10
1
M10
2
M10
2
M10
1
M10
1
M6
2
M5
2
2-17
TIGHTENING TORQUES
×3
×2
20
11
12
21
13
14
Tightening torque
68 Nm (6.8 m·kgf, 49 ft·lbf)
66 Nm (6.6 m·kgf, 48 ft·lbf)
68 Nm (6.8 m·kgf, 49 ft·lbf)
68 Nm (6.8 m·kgf, 49 ft·lbf)
68 Nm (6.8 m·kgf, 49 ft·lbf)
68 Nm (6.8 m·kgf, 49 ft·lbf)
68 Nm (6.8 m·kgf, 49 ft·lbf)
68 Nm (6.8 m·kgf, 49 ft·lbf)
68 Nm (6.8 m·kgf, 49 ft·lbf)
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
1.8 Nm (0.18 m·kgf, 1.3 ft·lbf)
Remarks
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the YZF-R25 and is the answer not in the manual?
Questions and answers
2016 model r25 balansör ve egzantirik zamanlama noktaları ve montajı
The balance and cam timing points and installation for the Yamaha YZF-R25 are described as follows:
- Balancer Drive Gear: Align the balancer drive gear between the projections on the lower side of the timing chain guide.
- Timing Chain Tensioner: Ensure the timing chain tensioner rod moves in and out smoothly. Replace it if there is any rough movement.
- Camshaft Installation:
1. Install the intake camshaft sprocket and exhaust camshaft sprocket.
2. Ensure the exhaust camshaft is identified by the groove on the camshaft as shown in the illustration.
3. Position the cam lobes as specified in the manual.
4. Tighten the camshaft sprocket bolts to the specified torque (20 Nm or 14 ft·lbf) using the rotor holding tool.
Proper alignment and torque specifications are crucial to avoid engine damage.
This answer is automatically generated
ISI.SENSERÜ.NEREDEDİR
ISI.SENSÖRÜ.NEREDE.MT.25İN