Oil Change Tripmeter; Shift Timing Indicator Light - Yamaha YZF-R25 Service Manual

• "AVE_ _._ L/100 km": The average amount of
fuel necessary to travel 100 km is shown.
To switch between the average fuel consump-
tion displays, push the "SEL" button for one sec-
ond.
To reset the average fuel consumption display,
push the "RES" button for at least one second.
TIP
After resetting the average fuel consumption dis-
play, "_ _._" is shown until the vehicle has trav-
eled 1 km (0.6 mi).

Oil change tripmeter

1
1. Oil change indicator "OIL"
2. Oil change tripmeter
The oil change tripmeter shows the distance
traveled since it was last reset (i.e., since the last
oil change).
The oil change indicator "OIL" will flash at the ini-
tial 1000 km, then at 5000 km and every 5000
km thereafter to indicate that the engine oil
should be changed.
After changing the engine oil, reset the oil
change tripmeter and the oil change indicator.
To reset them both, select the oil change tripme-
ter, and then push the "RES" button for one sec-
ond. Then, while "OIL" and the oil change
tripmeter are flashing, push the "RES" button for
three seconds. The oil change indicator will be
reset.
If the engine oil is changed before the oil change
indicator comes on (i.e., before the periodic oil
change interval has been reached), the oil
change tripmeter must be reset for the next peri-
odic oil change to be indicated at the correct
time.
2

Shift timing indicator light

1. Shift timing indicator light
2. Brightness level display
The shift timing indicator light has four settings
which can be adjusted.
• Flashing pattern: this function allows you to
choose whether or not the indicator light will
come on and whether it should flash or stay on
when activated.
• Activation point: this function allows you to se-
lect the engine speed at which the indicator
light is activated.
• Deactivation point: this function allows you to
select the engine speed at which the indicator
light is deactivated.
• Brightness: this function allows you to adjust
the brightness of the indicator light.
[To adjust the shift timing indicator light]
1. Turn the key to "
2. Push and hold the "SEL" button.
3. Turn the key to "
"SEL" button after five seconds. The shift tim-
ing indicator light can now be adjusted.
[To set the flashing pattern]
1. Push the "RES" button to select one of the fol-
lowing flashing pattern settings:
• On: the indicator light stays on when activat-
ed. (This setting is selected when the indica-
tor light stays on.)
• Flash: the indicator light flashes when activat-
ed. (This setting is selected when the indica-
tor light flashes four times per second.)
• Off: the indicator light is deactivated; in other
words, it does not come on or flash. (This set-
ting is selected when the indicator light flash-
es once every two seconds.)
1-7
FEATURES
1
2
".
", and then release the