Table of Contents
Advertisement
EWA13320
WARNING
Since the headlight bulb gets extremely hot,
keep flammable products and your hands
away from the bulb until it has cooled down.
5. Install:
New
• Headlight bulb
Secure the new headlight bulb with the head-
light bulb holder.
ECA13690
NOTICE
Avoid touching the glass part of the head-
light bulb to keep it free from oil, otherwise
the transparency of the glass, the life of the
bulb and the luminous flux will be adversely
affected. If the headlight bulb gets soiled,
thoroughly clean it with a cloth moistened
with alcohol or lacquer thinner.
6. Hook:
• Headlight bulb holder
7. Connect:
• Headlight coupler
8. Install:
• Headlight bulb cover "1"
TIP
Be sure to align the mark "a" on the headlight
bulb cover with the mark "b" on the headlight.
1
EAS30664
ADJUSTING THE HEADLIGHT BEAM
1. Adjust:
• Headlight beam (vertically)
▼
▼▼▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
a. Turn the adjusting screws "1" in direction "a"
or "b".
Direction "a"
Headlight beam is raised.
Direction "b"
Headlight beam is lowered.
a
b
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
PERIODIC MAINTENANCE
1
b
▲
▲▲▲
▲ ▲▲▲
▲
▼▼▼
3-28
a
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
1
b
a
▲ ▲▲▲
▲
▲▲▲
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the YZF-R25 and is the answer not in the manual?
Questions and answers
2016 model r25 balansör ve egzantirik zamanlama noktaları ve montajı
The balance and cam timing points and installation for the Yamaha YZF-R25 are described as follows:
- Balancer Drive Gear: Align the balancer drive gear between the projections on the lower side of the timing chain guide.
- Timing Chain Tensioner: Ensure the timing chain tensioner rod moves in and out smoothly. Replace it if there is any rough movement.
- Camshaft Installation:
1. Install the intake camshaft sprocket and exhaust camshaft sprocket.
2. Ensure the exhaust camshaft is identified by the groove on the camshaft as shown in the illustration.
3. Position the cam lobes as specified in the manual.
4. Tighten the camshaft sprocket bolts to the specified torque (20 Nm or 14 ft·lbf) using the rotor holding tool.
Proper alignment and torque specifications are crucial to avoid engine damage.
This answer is automatically generated
ISI.SENSERÜ.NEREDEDİR
ISI.SENSÖRÜ.NEREDE.MT.25İN