Siemens Sinumerik 840C Diagnostics Manual page 157

04/96
160028 Illegal shift factor parameterized
Scan
When starting DAC output
Effect
DAC output cannot be started
Explanation
Shift factor is outside permissible range
Remedy
Correct shift factor
160029 Missing target hardware
Scan
When starting DAC output
Effect
DAC output cannot be started
Explanation
–
Remedy
–
160030 Non-available DAC started
Scan
When starting DAC output
Effect
DAC output cannot be started
Explanation
A drive module which is not configured has been selected
Remedy
Select available drive module
160031 Max. number of servo signals exceeded
Scan
When starting DAC output
Effect
DAC output cannot be started
Explanation
A maximum of 4 SERVO signals can be output through DAC channels
Remedy
Reduce number of output SERVO signals
160032 Max. number of active DACs exceeded
Scan
Parameterization/starting DAC output
Effect
DAC output cannot be started
Explanation
Internal startup application error
Remedy
End application and repeat procedure
160033 DAC busy from other half of two-axis module
Scan
Parameterization/starting DAC output
Effect
DAC output cannot be started
Explanation
Three DAC channels exist on two-axis modules for both axes
Remedy
Select other output channel and repeat procedure or stop busy DAC
160034 No axis configured
Scan
When selecting startup menus for axes
Effect
Startup menu for axes disabled
Explanation
Startup menu for axes needs at least one NC axis
Remedy
Enter NC axis configuration
160035 No drive module configured
Scan
Selecting menu for DAC output
Effect
Startup menu for DAC is disabled
Explanation
Menu for DAC output needs at least one 611D module
Remedy
–

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
1 Alarms
1.5.1 Alarm description
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
1–149