Huawei eSpace 6805 User Manual page 21

Huawei IP Phone eSpace
User Manual
Menu
Config
Factory
Functions
Network
Reboot
Exit
68105
Configuration Description
Display the configuration submenus.
[SIP]

Set the SIP server for each account, including Account, SIP
proxy, Outbound proxy, SIP user ID, SIP Auth ID, SIP
password, SIP transport, and Audio CODECs.
[Upgrade]

Configure the firmware server and the file download server.
Select either TFTP or HTTP to upgrade the firmware or
configure the phone.
[Factory Reset]

Type the MAC address on back of the phone. Press OK
softkey to restore the factory reset settings. Factory reset
clears all configurations and restores the phone to factory
settings.
[Layer 2 QoS]

Configure the 802.1Q VLAN tag and 802.1P priority.
Press LEFT or select Back to return to the main menu.
These items are used for factory testing and not recommended for
users.
[Audio Loopback]

Speak to the handset. If you hear your voice in the handset,
your audio works well. Press MENU to exit the mode.
[Diagnostic Mode]

All LEDs are on. Press any key on the keypad to display the
key name on the LCD. Pick up the handset or press MENU to
exit the diagnostic mode.
Press LEFT or select Back to return to the main menu.
Enable or disable the DHCP protocol. Set the IP address, subnet
mask, and gateway address by using the keypad if the static IP
mode is selected.
Reboot the device.
Exit the menu.
4 Configuring the eSpace 6805
16